PLU65-500012 - PULSE LIPO 5000mAh 44.4V 65C STICK VERSION
Cell Count: 12S
Discharge Rate: 65C
Charge Rate: 5C
Dimensions: 320mm x 50mm x 51mm (LxWxH)
Balance Tap: JST-XH
12S 44.4V Wiring:
Use a bullet style connector (male and female) to join the two (2) yellow wires - one male, and one female. This connector should be 5mm or larger, which allows the pack to be broken into two 6S packs for charging.
For the positive / negative (red & black) wires, these will solder to a standard connector of your choice, such as an EC5 connector. Once soldering is complete, the (2) yellow wires can be joined together, which will tie both packs into (1) 12S 44.4 battery, outputting 12S 44.4V power via the connector attached to the positive / negative (red & black) wires. This setup negates the need for a series connector, simplifying the wiring setup. You will need to make a custom charge lead for each 6S pack to allow each 6S battery to be charged independently.
Be extremely careful with polarity! Polarity reversals can cause serious damage to the battery, and can inflict serious harm - any such polarity reversals are NOT covered under warranty, and all such battery setups are the sole responsibility for the end user.